Description
The TEIN RX1 suspension package for Toyota Prius Prime applications detailed below is intended for adjustable road suspension with hydraulic bump control. Its spring, damper and mounting configuration should be selected as a complete application rather than by vehicle name alone.
Representative image: Photos illustrate the product series or component type. Actual product appearance, dimensions, mounting configuration, and included hardware may vary by application. Refer to the listed part number, specifications, and included components for the product supplied.
Design and adjustment
RX1 combines twin-tube construction, full-length height adjustment and 16-level combined compression/rebound damping adjustment. Hydraulic Bump Stopper technology adds resistance near full compression to help absorb larger suspension inputs.
Upper mounts and alignment-adjustment hardware vary by application. Camber-adjustable lower brackets are offered on applicable strut designs, not universally on every kit.
Product identification
| Item | Detail |
|---|---|
| Manufacturer part number | VSTD2-M1AS3 |
| Series | RX1 |
Application-specific specifications
| Application | Front spring rate | Rear spring rate | Front reference height change | Rear reference height change |
|---|---|---|---|---|
| Toyota Prius Prime 2018–2022 (ZVW52), PHEV, 1800 cc, FWD | 4 kgf/mm | 5 kgf/mm | -35 mm (-1.4 in) | -30 mm (-1.2 in) |
Height figures are changes relative to the original suspension: negative values indicate lowering and positive values indicate a raised height. Inch figures are rounded conversions. Actual installed height depends on vehicle condition, equipment and setup.
| Application | Front upper mount | Rear upper mount |
|---|---|---|
| Toyota Prius Prime 2018–2022 (ZVW52), PHEV, 1800 cc, FWD | Reinforced-rubber mount | Reinforced-rubber mount |
| Application | Recommended front height-change range | Recommended rear height-change range |
|---|---|---|
| Toyota Prius Prime 2018–2022 (ZVW52), PHEV, 1800 cc, FWD | -45 to -25 mm | -40 to -20 mm |
Vehicle application
| Years / production dates | Make | Model | Chassis | Trim / restriction | Engine displacement | Drivetrain | Market |
|---|---|---|---|---|---|---|---|
| 2018–2022 | TOYOTA | PRIUS PRIME | ZVW52 | PHEV | 1800 cc | FWD | USA |
Match the chassis, market and equipment above. Dates shown for non-US markets can be production dates rather than US model years; an open-ended application is not confirmation for a later redesigned chassis.
Included configuration
The application record identifies springs as included with this suspension kit. Upper-mount configuration is shown separately above; components marked as original are reused from the vehicle.
Installation and setup
Set the suspension within its application-specific recommended height range, check clearance through steering and suspension travel, and align the vehicle after fitting. Change damping settings progressively where adjustment is available; the firmest setting is not automatically the most suitable.
Application-specific installation notes
- Toyota Prius Prime 2018–2022 (ZVW52): Front: shock absorber needs to be detached from vehicle, when adjusting damping force. Ft/Rear: use of EDFC series is recommended, as it's difficult to adjust damping force by hand.
