Description
This KONIG hub-ring set provides the dimensional interface between a compatible wheel with a 73.1mm center bore and a vehicle hub measuring 60.1mm. The outer diameter seats in the wheel, while the inner diameter fits over the vehicle hub pilot.
Specifications and compatibility
- Manufacturer part number: HR736010AL
- Outer diameter: 73.1mm
- Inner diameter: 60.1mm
- Quantity: Four rings
- Material: Aluminum
Selection and installation
Confirm both diameters and the ring seating profile before ordering. Nominal diameter alone does not establish compatibility with every wheel design.
Hub rings assist with centering during installation. They do not change bolt pattern, offset, or brake clearance and do not replace correct wheel hardware or tightening procedures.
The ring must seat correctly so the wheel mounting face sits flat against the hub.
A light coating of anti-seize on the ring contact surfaces can help prevent corrosion-related sticking. Keep it away from lug-seat surfaces and follow the vehicle and wheel hardware instructions.
This ring is not compatible with KONIG Helium or Rewind wheels.