TEIN S.TECH Lowering Springs – 2008–2017 Mitsubishi Lancer (CY4A)

Save $72
TeinSKU: TEINSKE20-S3B00

Price:
$288 $360

Description

This S.TECH spring kit is selected for Mitsubishi Lancer applications detailed below. It changes the spring and ride-height specification while retaining the vehicle’s compatible original-style damper arrangement.

Representative image: Photos illustrate the product series or component type. Actual product appearance, dimensions, mounting configuration, and included hardware may vary by application. Refer to the listed part number, specifications, and included components for the product supplied.

The S.TECH spring family offers an application-specific lowering option without converting to a height-adjustable coilover system. Spring rate controls how much the suspension deflects under load; the dampers still determine how that movement is controlled.

Product identification

Item Detail
Manufacturer part number SKE20-S3B00
Product family S.TECH
Configuration Lowering spring kit; dampers are not included

Application-specific specifications

Application Front spring rate Rear spring rate Front reference height change Rear reference height change
Mitsubishi Lancer 2008–2017 (CY4A), ES, 2000 cc, FWD 3.9 kgf/mm 2.8 kgf/mm -54 mm (-2.1 in) -36 mm (-1.4 in)
Mitsubishi Lancer 2009–2017 (CY5A), GTS, 2400 cc, FWD 3.9 kgf/mm 2.8 kgf/mm -50 mm (-2.0 in) -30 mm (-1.2 in)

Height figures are changes relative to the original suspension: negative values indicate lowering and positive values indicate a raised height. Inch figures are rounded conversions. Actual installed height depends on vehicle condition, equipment and setup.

Vehicle application

Years / production dates Make Model Chassis Trim / restriction Engine displacement Drivetrain Market
2008–2017 MITSUBISHI LANCER CY4A ES 2000 cc FWD USA
2009–2017 MITSUBISHI LANCER CY5A GTS 2400 cc FWD USA

Match the chassis, market and equipment above. Dates shown for non-US markets can be production dates rather than US model years; an open-ended application is not confirmation for a later redesigned chassis.

Installation and setup

Inspect the dampers, upper mounts and spring isolators before installation. Lowering reduces available clearance and can change alignment. Follow the application-specific bump-stop instructions and check alignment and tire clearance after fitting.

Application-specific installation notes

  • Mitsubishi Lancer 2008–2017 (CY4A): 4dr/4cyl. Front: cut bump rubber at 20 mm and 60 mm from the top and use the upper and lower portions. The middle part is not needed. Rear: cut bump rubber at 43 mm and 63 mm from the top and use the upper and lower portions. The middle part is not needed.
  • Mitsubishi Lancer 2009–2017 (CY5A): 4dr ff gts(2.4l). Front: cut bump rubber at 20 mm and 60 mm from the top and use the upper and lower portions. The middle part is not needed. Rear: cut bump rubber at 43 mm and 63 mm from the top and use the upper and lower portions. The middle part is not needed.

Estimate shipping

You may also like

Recently viewed